Verilink Access Manager 2000 (896-502037-001) Product Manua Manual de usuario descargar pdf (Pagina 212)

Configuring the T1 Network

5-88

Access Manager 2000 User Manual

This option functions like Signal to EQP on LOS option

described below, except the trigger condition is LOF. See warning in that

section. The default is YES.

If this option is set to YES, then whatever signal is received from the

network is sent to the equipment.

If this option is set to NO, then AIS is sent to the equipment until the LOS

alarm clears. The default is YES (signal).

CAUTION

Setting this option to NO causes an out-of-service condition during

LOS from the network, starting when the condition is detected and

lasting as long as the condition persists plus from 0 seconds to 255

seconds (depending on the user-selected alarm delay time). The

default is 10 seconds.

This option is functionally similar to the EQP Receive Jitter

Buffer = 40 Bits option, except that the buffer in this option is for

the incoming signal from the network. The default setting is YES.

When set to YES (the default), the ESF Data Link idle code is ALL-

ONEs. When this option is set to NO, the Data Link idle code is Flags.

Set this option to YES (default) to allow the CSU to automatically

perform a self-test each time it is powered up.

Set this option to YES (default setting) if you want the CSU to respond to

loopback commands sent to it either on the ESF Data Link or directly

from Access Manager.

Signal to EQP on

NET LOF

Signal to EQP on

NET LOS

NET RCV Jitte

BUF = 40 Bits

Data Link Idle

Code (Idle code) =

Flags

Power-up Near End

Self Test

Loopback Enable

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 399 400

Sin comentarios

Verilink Access Manager 2000 (896-502037-001) Product Manua Manual de usuario Pagina 212