Verilink 8100A (34-00237) Product Manual Manual de usuario Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 311
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
3-16 8000 Series
Set System Defaults
You may set the IAD to boot from the previously saved custom configuration,
or boot from the factory-supplied configuration file as described below.
1 Type “D” on the Utilities menu. The IAD displays the following menu:
Figure 3.7
System Default Menu
2 Type “1” to set the previously saved custom configuration file as the boot
file
—or—
Type “2” to set the default.st config file as the boot file.
3 The IAD displays a warning and asks you to confirm your decision.
4 Type “Y to confirm the process. The IAD updates the setting and displays
the Utility menu.
5 Reset the IAD to reboot with the new config file.
Save System Settings as Defaults
To save the current configuration as the custom default configuration, follow
the steps below.
1 Type “W” on the Utilities menu.
When the IAD is configured as a DHCP client, the following question is
asked:
This unit is configured as a DHCP client. Do you
want a defaulted unit to TFTP download a
configuration file from the IP address specified in
the ‘siaddr’ field returned by the DHCP server after
booting?
Press Y to download configuration on boot->
If you type “Yin answer to this prompt, a defaulted IAD will download its
configuration file via TFTP from a file named MAC-address.cfg on the server
indicated by DHCP information.
2 The IAD displays a warning and asks you to confirm your decision to save
custom defaults.Type “Y” to save the current configuration as custdef.st, a
custom default configuration file.
The IAD saves the custom configuration file and displays the Utility menu.
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 310 311

Comentarios a estos manuales

Sin comentarios