Verilink 8100A (34-00237) Product Manual Manual de usuario descargar pdf (Pagina 240)

7-2 8000 Series

POTS Diagnostics

A WAN uplink is not required to perform POTS testing. To perform POTS

diagnostics, type “P” on the Diagnostics Menu. The IAD loads and

configures the DSP software module, and displays the following menu:

Figure 7.3

POTS Diagnostics Menu

CAUTION: Pots diagnostics are intrusive tests. Any active calls will be

terminated. You should terminate all voice gateway activity prior to

employing POTS diagnostic testing. The Infineon CODEC test is

reserved for Verilink use only.

To perform a specific test, type the option and proceed to the appropriate

section below.

Dialup Test

The dialup test verifies the operational status of each telephone station by

allowing the user to dial another POTS phone on the IAD by dialing the port

number. To perform a dialup test, follow the steps below.

1 Type “D” on the POTS Diagnostics menu to select Dialup Test. The IAD

displays this prompt:

Dialup test mode...

Pick up any handset and dial the number of the line

you want to test

2 Take the selected handset offhook, listen for dial tone, and dial the port

number. Hang up after a successful connection. The IAD reports the status

of each action:

Line 1 off-hook

Line 1 hung up

Line 5 off-hook

Line 5 hung up

3 Press Escape to terminate the test. The IAD terminates the test and displays

the menu.

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 310 311

Sin comentarios

Verilink 8100A (34-00237) Product Manual Manual de usuario Pagina 240