Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario descargar pdf (Pagina 37)

Web Server Interface 3-13

DTE on the Serial interface. If set to “Forced True,” RTS is always perceived

as “On.”

Values: Normal, Forced True

Default: Normal

RTS/CTS Delay

The Request To Send/Clear To Send parameter determines how long the unit

waits before it changes the level of CTS to match RTS when the CTS

parameter is set to “Internal.”

Values: Normal (~30 ms delay), Long (~100 ms delay)

Default: Normal

Flow Control

Selects the type of flow control to be used if the port is asynchronous.

Values: None, Xon/Xoff, RTS/CTS

Default: None

Current Pin Status

The Current Pin Status, which shows the state of the RS-232 pins, is also

displayed on the Serial interface screens.

DTR Alarm Control and Status Table

In addition to the configurable fields, the Serial screen displays a table that

lets you set the Data Terminal Ready (DTR) Alarm Control parameters and

view the current DTR Alarm Status.

Choices for DTR Alarm Control are “Enable” and “Disable”; the default

setting is “Disable.” Setting DTR Alarm Control to “Enable” allows the unit

to go into alarm on a loss of DTR, which occurs when the Serial port detects

that the DTR signal is low. The DTR Status field indicates the current state of

the DTR alarm.

10/100 Ethernet (IP Service Details) Screen

The 10/100 Ethernet (IP Service Details) screen (Figure 3.9) lets you

configure the IP parameters described below.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 152 153

Sin comentarios

Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario Pagina 37