Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario Pagina 131

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 153
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 130
Front Panel LCD Interface 5-13
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Network Configuration Menu
Use the NET CONFIG menu to set up parameter values for the T1 port
labeled as
NET” as shown in Figure 5.12.
Figure 5.12
Network Configuration Menu Tree
The Network interface can have independently selected values for the
following parameters:
Mode
Selects the network service type.
Values: Long Haul, Short Haul
Default: Long Haul
LBO
Sets the transmit Line Build Out (LBO) for the network interface.
Values: 0, 7.5, 15.0, 22.5 dB
Default: 0 dB
Framing
Selects the framing for the network side of the DSU/CSU.
Values ESF, D4
Default: ESF
Coding
Sets the network side line coding.
Values: AMI, B8ZS
Default: B8ZS
Timing
Sets the timing source to synchronize the unit’s internal timing generators. In
all cases, slips are controlled to occur on frame boundaries at the Network
and/or DSX-1 ports when timing synchronization is lost. Choices are as
follows:
InternalThe unit’s internal frequency standard (T1 1.544 Mbps ± 50 bps)
is used for all timing.
Net – Timing is derived from the Network port recovered clock.
Net
Config
Framing Coding TimingLBO
ESF
D4
B8ZS
AMI
Int
Net
Serial
0
7.5
15.0
22.5
Zero Suppression
Dis
En
PRM
Dis
En
Mode
Long-Haul
Shrt-Haul
Vista de pagina 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 152 153

Comentarios a estos manuales

Sin comentarios