Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario descargar pdf (Pagina 114)

4-40 FrameStart FSM

Figure 4.30

Network Test Details Screen

BERT Table on Network Interface Test Details Screen

The BERT table provided on the Test Details screen lets you set the test

parameters listed below.

Setting

Displays the bandwidth on which you wish to perform the BERT. The

available values for this parameter depend on which interface is selected.

Values: Net, Use Service, Idle, Channel 1...24,

Default: Net

BERT Pattern

Specifies the pattern to be transmitted during a test for the selected port.

Values: Marks, QRSS, 511, 2047, 2

, Spaces

Default: QRSS

NOTICE: The 2

pattern is the ITU (European) version, not the ANSI version.

Test Duration

Specifies the length of time for which the test should run for the selected port.

Values: 15 minutes, 30 minutes, 1 hour, 24 hours, Continuous

Default: 15 minutes

From this screen, you can also view the following read-only parameters:

Service Index

Selects the channels with a service to BERT. (Refer to the Service Table

Screen shown on page 4-17.)

Rate

Sets the bit rate to BERT for each selected channel. If “Νx64K” is selected,

the ones density requirements of the T1 network line must be ensured. If

“Νx56K” is selected, ones density for the selected DS0 channel is maintained.

Values: Nx56K, Nx64K

Default: Nx64K

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 152 153

Sin comentarios

Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario Pagina 114