Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario descargar pdf (Pagina 150)

B-2 FrameStart FSM

• rfc2863.mib − describes generic objects for network interface sub-layers

(This MIB is an updated version of MIB-II's ifTable, and

incorporates the extensions defined in RFC 1229.)

• rfc2493.mib − provides textual conventions to be used by systems

supporting 15-minute based performance history counts

• rfc2115.mib − describes the use of a Frame Relay interface by a DTE

• rfc2495.mib − describes DS1, E1, DS2 and E2 interfaces objects

• rfc2011.mib − for managing IP and ICMP implementations, but excluding

their management of IP routes

• rfc2012.mib − for managing TCP implementations

• rfc2013.mib − for managing UDP implementations

• rfc2096.mib − for the display of CIDR multipath IP routes

• rfc2571.mib − the SNMP Management Architecture MIB

The FrameStart FSM supports the following Enterprise-specific MIBs:

• ds8200tc.mib − textual conventions used by DS8200 MIB

• ds8200v2.mib − provides T1 configuration and statistics information

• ipadv2.mib − provides Frame Relay and PPP configuration and statistics

• ipstart.mib − MIB module for synchronous PPP

These MIB files may be found on the Verilink Documentation CD included

with the unit.

SNMP Trap Configuration

The FSM supports up to eight IP destinations for SNMP traps. These may be

configured either through the Web interface or through an SNMP

management application. For configuration of these destinations through an

SNMP management application, use a MIB browser to access the table

trapdest within ipadv2.mib and set the IP addresses of the host

computer running the management application(s). Entering an IP address of

0.0.0.0 will disable the entry.

Generic MIB Loading Instructions

The MIBs were written using the standard ASN.1 notation. Any standard SNMP

manager should be able to compile the MIBs. Although the exact procedure for

loading MIBs may vary from one platform to another, the following basic steps

are the same.

1 The SNMP manager has a directory for MIBs. Copy the files

ds8200tc.mib, ds8200v2.mib, ipadv2.mib, ipstart.mib,

router.mib, and hds12.mib into this directory. The MIBs use a

DOS format; therefore, a DOS2UNIX command may have to be used for

UNIX workstations (typical directories are snmp_mibs for HP’s

1 2 ... 145 146 147 148 149 150 151 152 153

Sin comentarios

Verilink FrameStart FSM (34-00299.E) Product Manual Manual de usuario Pagina 150