Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario descargar pdf (Pagina 25)

About the WANsuite 5160/5130 1-11

NOTICE: For information on pinout assignments for this connector, refer to

Supervisory Port Pin Assignments on page A-10. See Ordering

Information on page A-6 for information on cables for this connector.

The Supervisory port performs several different functions. It serves as the

VT100 interface port, providing VT100 screens. It also supports asynchronous

PPP, providing access to the Web Server interface. In addition, the

Supervisory port is an asynchronous data port. Data is encapsulated in frame

relay packets and then transmitted through the Network port.

On power-up, the Supervisory port sends out diagnostic messages at the bit

rate of 115.2 kbps until the Supervisory service acquires the Supervisory port.

These diagnostic messages can disrupt the connected device; however, you

can configure the unit to disable their transmission.

NOTICE: A null modem (crossover) cable is required to connect a modem to the

Supervisory port.

10/100 Ethernet

The WANsuite 5160/5130 provides one 10/100 ETHERNET interface. This

interface is an eight-pin modular jack that complies with standard

twisted-pair, 10/100Base-T requirements. The 10/100Base-T cable is supplied

by the end user. Refer to Ethernet Connection Pin Assignments on page A-9

for pin assignments and cable descriptions.

Ethernet LED Indicators

There are two unlabeled indicator LEDs on either side of the

10/100 ETHERNET jack. The LED on the left side of the jack pulses amber to

indicate data activity (either transmit or receive). The LED on the right side of

the jack lights green to indicate that the link layer is operational.

Serial Interface(s)

The two SERIAL interfaces on the 5160 and the single SERIAL interface on

the 5130 located on the rear of the units are multi-protocol interfaces

presented physically as DB-25 connections. The protocols supported by these

interfaces are RS-232, EIA-530, and V.35.

Optional cables that adapt the DB-25 interface to the 34-pin V.35 interface

are available. These cables are listed under Optional Equipment on page A-6.

DB-25–to–DB-25 cables are also available if your installation needs require

them. See Ordering Information on page A-6 for details. Pin assignments for

the Serial interface are also listed in Appendix A, Specifications.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 262 263

Sin comentarios

Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario Pagina 25