Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario Pagina 145

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 263
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 144
VT100 Interface 4-17
Current Pin Status
The Current Pin Status, which shows the state of the RS-232 pins, is also
displayed on the Serial interface screens.
10/100 Ethernet (IP Details) Screen
If you select “Ethernet” from the Interfaces screen, you will bring up an IP
Details screen (Figure 4.12) that lets you view and/or modify the IP
parameters listed below.
Figure 4.12
IP Details Screen
Unit IP Address
A unique Network address assigned to this unit.
Subnet Mask
Defines the Network portion of the unit’s IP address.
Gateway IP Address
IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier
Displays a unique identifier for a specific IP address.
Ethernet
Enables or disables a remote unit’s Ethernet port.
Physical Address
Displays unique MAC address.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Vista de pagina 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 262 263

Comentarios a estos manuales

Sin comentarios