Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario descargar pdf (Pagina 183)

VT100 Interface 4-55

“No Sync” is displayed. If the receiver is in pattern sync, “In Sync” is

displayed.

Elapsed Time

Displays the time elapsed since a timed test began or, if completed, the total

test time.

Bit Errors

Displays the total number of bit errors detected since the test began or since

error statistics were cleared.

Errored Seconds

Displays the number of asynchronous errored seconds that have been detected

since the test began or since error statistics were last cleared.

%EFS

Displays the percentage of time that the test ran error-free. This ratio is

derived from the number of error-free seconds divided by the number of

seconds accumulated in Elapsed Time.

Loop Table on Network Interface Test Details Screen

The Loop table lets you specify the type of Loop test to be performed. The

types of tests available for you to choose from depend on the currently

selected interface. Loopback diagrams are shown in Appendix A, Figure A.1.

Values: No Test (Loop Down), payload loopback (PLB), line loopback

(LLB), maintenance loopback (MLB), Far PLB, and Far LLB

Default: No Test (Loop Down)

Figure 4.48

Serial Interface Test Details Screen

BERT Table on Serial Interface Test Details Screen

The BERT table lets you set the test parameters listed below.

Setting

Displays the bandwidth on which you wish to perform the BERT. The

available values for this parameter depend on which interface is selected.

Values: Net, DTE

Default: Net

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 262 263

Sin comentarios

Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario Pagina 183