Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario descargar pdf (Pagina 141)

VT100 Interface 4-13

CAUTION: Performance data will be lost upon power cycle or after performing a

Maintenance Reset/Restart.

Serial Screens

The Serial 1 and Serial 2 screens on the WANsuite 5160 or Serial screen on

the WANsuite 5130 let you view and make changes to the unit’s Serial

interface configuration as described below. The parameters on all Serial

screens are the same except for the Invert Clock parameter, which is found

only on the Serial 2 screen; therefore, the WANsuite 5160 Serial 2 screen

(Figure 4.11) is the only one shown below.

To make changes to any Serial parameter, simply set the parameter to the

desired selection and press the “Esc” key.

Figure 4.11

Serial 2 Screen

Type

This parameter selects the type of interface (based on its electrical signal

characteristics) used by the equipment connected to the Serial port.

Values: V.35, RS-232, EIA-530

Default: V.35

NOTICE: V.35 requires the use of an optional cable. Refer to Appendix A,

“Specifications,” for ordering information.

Mode

By default, the Serial port serves as a DCE port in both Packet and TDM

modes. However, the Serial port can serve as a DTE port when the unit is in

Packet mode.

If the Serial port connects to a DTE device (such as a FRAD or a router), the

Mode parameter must be set to “DCE.” If this port connects to a DCE device

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 262 263

Sin comentarios

Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario Pagina 141