Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario descargar pdf (Pagina 173)

VT100 Interface 4-45

CIR (bps)

If a Committed Information Rate is configured here, its value (in bits per

second) will be used instead of the default CIR of the frame relay service.

Values: 0–1536000

Default: 0

Be (bps)

If an Excess Burst Rate is configured here, its value (in bits per second) will

be used instead of the default excess burst of the frame relay service.

Values: 0–1536000

Default: 0

Bc (bps)

If CIR enforcement is configured to “Yes,” the unit will throttle the

Committed Burst down to this value (in bits per second) when frames are

received with the BECN bit set.

Values: 0–1536000

Default: 0

Discard Eligible Flag

If this parameter is set to “Yes,” and CIR enforcement is also set to “Yes,” the

unit will set the Discard Eligible (DE) bit for frames sent over CIR.

Values: Yes, No

Default: No

In Band Management

If the unit is to be used as a gateway to reach a remote WANsuite 5160/5130

through this DLCI, set this parameter to “Yes,” and configure the remote IP

address and Mask in the corresponding endpoint.

Values: Yes, No

Default: No

FrameStart Delay

If this parameter is set to “Enable,” the unit will send FrameStart discovery

and delay frames on this DLCI, and will report the state of the remote

Verilink unit. It will also send SOS frames when the FRAD/router connected

to this unit goes inactive.

Values: Enable, Disable

Default: Enable if Auto Discovery is set to “Yes”; otherwise Disable

FrameStart Status

If the remote unit is a Verilink unit with FrameStart technology and

FrameStart Auto Discovery is enabled, the FrameStart Status field will show

the status of the remote unit. The status is “Active” if both the local and

remote DLCIs are active and the remote unit answers to the discovery frames

sent by this unit. The status is “SOS” if the remote unit is active but the

FRAD/router connected to it is inactive. The status is “Inactive” in all other

cases.

Values: Active, Inactive, SOS

Default: Inactive

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 262 263

Comentarios a estos manuales

Sin comentarios

Verilink WANsuite 5130 (34-00298.L) Product Manual Manual de usuario Pagina 173

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink WANsuite 5130 (34-00298.L) Product Manual