Verilink WANsuite 7105 (34-00316.C) Product Manual Manual de usuario Pagina 90

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 255
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 89
3-58 WANsuite 7105
Figure 3.50
Network Interface Test Details Screen
BERT Table on the Network Interface Test Details Screen
The BERT table lets you set the parameters listed below.
Setting
Displays the bandwidth on which you wish to perform the BERT. The
available values for this parameter depend on which interface you select.
Values: Idle, Channel 1...24, Net, Use Service
Default: Net
Service
Selects the channels with a service to BERT (see Services Screen on
page 3-22).
Channel Rate
Sets the bit rate to BERT for each selected channel. If “Nx64K” is selected,
the ones density requirements of the T1 network line must be ensured. If
“Nx56K” is selected, ones density for the selected DS0 channel is maintained.
Values: Nx56K, Nx64K
Default: Nx64K
NOTICE: The Service and Channel Rate parameters will appear only on Network
screens.
BERT Pattern
Specifies the pattern to be transmitted during a test for the selected port.
Values: Marks, QRSS, 511, 2047, 2
15
, Spaces
Default: QRSS
NOTICE: The 2
15
pattern is the ITU (European) version, not the ANSI version.
Vista de pagina 89
1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 254 255

Comentarios a estos manuales

Sin comentarios