Verilink WANsuite 7105 (34-00316.C) Product Manual Manual de usuario Pagina 153

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 255
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 152
VT100 Interface 4-19
Parity
Sets the parity bit if the port is asynchronous.
Values: None, Odd, Even
Default: None
Stop Bit
Selects the number of bits required to end the asynchronous character.
Values: 1, 2
Default: 1
Current Pin Status
Shows the status of the DTE Serial port pins.
Ethernet (IP Details) Screen
If you select “Ethernet” from the Interfaces screen, you will bring up an IP
Details screen (Figure 4.12) that lets you view and/or modify the IP
parameters listed below.
Figure 4.12
IP Details Screen
Unit IP Address
A unique network address assigned to this unit.
Subnet Mask
Defines the network portion of the unit’s IP address.
Gateway IP Address
IP address of the default gateway (router) on the LAN side of the unit.
DHCP Client
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
Client Identifier
Displays a unique identifier for a specific IP address.
Ethernet
Enables or disables a remote unit’s Ethernet port.
Physical Address
Displays unique MAC address.
Vista de pagina 152
1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 254 255

Comentarios a estos manuales

Sin comentarios