
28 CHAPTER 2: INSTALLATION
9111 Port 1
DDS Option
Testing
Remote Channel Loop
This loop is activated by
receiving a minimum of four
consecutive bytes of the
non-latching loopback code at
the proper data rate and remains looped as long as every other byte contains the
loopback code and continues for a minimum of four consecutive bytes after
receiving the last loopback code. Figure 2-8 shows the channel loop.
Port 2
Port 2 is a DTE
port. Its
interface is
RS-232 or V.35,
depending on a
jumper on the
main PCB. The
default is V.35.
To change this
jumper, see
Figure 2-9.
Table 2-13
shows the
pinout of Port 2.
DTE
NET
Figure 2-8
Channel Loop
able 2-13
Port 2 Pinout
Signal
RS-232C
Circuit Pin
V.35
Circuit
Pins
A/B
Shield Ground AA 1 FG 1
Transmit Data BA 2 SD 2/14
Receive Data BB 3 RD 3/16
Request to Send CA 4 RTS 4
Clear to Send CB 5 CTS 5
Data Set Ready CC 6 DSR 6
Signal Ground AB 7 SG 7
Data Carrier Detect CF 8 RLSD 8
Transmit Clock DB 15 SCT 15/12
Receive Clock DD 17 SCR 17/9
DTE Ready CD 20 DTR 20
External Clock DA 24 SCTE 24/11
Comentarios a estos manuales