Verilink T1 Access Router (34-00327) Product Manual Manual de usuario Pagina 79

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 197
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 78
Web Server Interface 3-51
RIP Status
Indicates whether or not RIP is enabled on this circuit.
Values: Enable, Disable
Default: Enable
Multicast Status
Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
OSPF Status
Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Disable
OSPF Area
Represents the area that this circuit is part of.
OSPF LSA Timer
Determines how often the Link State Acknowledgment (LSA) packet is sent.
Values: 13600
Default: 1
OSPF LSU Delay
The estimated number of seconds it takes to transmit a Link State Update
(LSU) packet over this circuit interface.
Values: 13600
Default: 1
OSPF Router Priority
This 8-bit unsigned integer ranges from 1 to 255 and assigns priority to one of
two routers attached to the same network; without an assigned priority, both
routers attempt to become the designated router.
Values: 1255
Default: 1
OSPF Hello Interval
The time in seconds between the Hello packets that a router sends on a
circuit. This value is also advertised in the router’s Hello packets and must be
identical for all routers on the same network. The smaller the Hello Interval,
the sooner topological changes are detected (but then more traffic is created).
Values: 165535
Default: 1
OSPF Dead Interval
The number of seconds during which a router’s “Hellos” have not been
received before its neighbors declare the router down. The value must be the
same as the value on the network.
Values: 165535
Default: 40
OSPF Auth Key
When configured, this parameter allows an authentication procedure to be
executed on the OSPF header. If the 64-bit (8 character) password does not
correspond, the packet is thrown away.
Values: 64 bits (8 characters)
Default: 8 spaces (no authentication)
Vista de pagina 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 196 197

Comentarios a estos manuales

Sin comentarios