Verilink T1 Access Router (34-00327) Product Manual Manual de usuario descargar pdf (Pagina 193)

SNMP Agent B-1

A PPENDIX

PPENDIX

SNMP A

GENT

Introduction

This chapter provides specific information for configuring and using the

SNMP agent within the T1 Access Router.

The T1 Access Router incorporates an Ethernet card that provides

connectivity for LAN-based management stations. The embedded TCP/IP

Protocol Stack allows remote access from both private networks and the

Internet.

SNMP Configuration Parameters

To access the SNMP agent, you must have an SNMP management

application, such as HP’s OpenView

or Sun’s NetManager . Access to the

agent is controlled by three community strings, read-access, write-access, and

trap-access (the community string sent with an SNMP trap). Configuration of

these community strings within the T1 Access Router is accomplished via the

HTTP (web browser) interface. Please refer to Chapter 3, Web Server

Interface, for instructions on how this is performed.

The defaults for these strings are “public” for read-access, “private” for write-

access, and “public” for trap-access. Ensure that your SNMP management

application is configured for whatever access strings you use.

SNMP MIBs

The T1 Access Router supports the following industry-standard MIB

(management information base) files:

• rfc1907.mib − SNMPv2 entities (initial revision published as RFC 1450)

• rfc1573.mib − defines the IANAifType textual convention, and thus the

enumerated values of the ifType object defined in MIB-II’s

ifTable

1 2 ... 188 189 190 191 192 193 194 195 196 197

Sin comentarios

Verilink T1 Access Router (34-00327) Product Manual Manual de usuario Pagina 193