Verilink T1 Access Router (34-00327) Product Manual Manual de usuario Pagina 21

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 197
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 20
About the T1 Access Router 1-7
The user-activated input control buttons on the T1 Access Router are
described in the following table.
*The CONFIG button must be held until the MODE LED lights amber and remains illuminated for the
default configuration to take effect.
Rear Panel Connections
The rear panel of the T1 Access Router has four connectors POWER,
SUPERVISORY PORT, 10/100 ETHERNET, and NET as shown in Figure 1.2
below.
Figure 1.2
T1 Access Router Rear Panel
The following paragraphs describe the T1 Access Router connectors.
Supervisory Port
The SUPERVISORY PORT on the T1 Access Router is a DB-9 female DCE
connector configured for 8 bits, no parity, and 1 stop bit. Bit rates are
configured through the Web server (see Supervisory on page 3-13) or VT100
interface. The Supervisory port speed can be set to 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200 bps. The initial default rate of the Supervisory
port is 19200 bps.
On power-up, the Supervisory port sends out diagnostic messages at the bit
rate of 115.2 kbps until the Supervisory service acquires the Supervisory port.
ALARM
The ALARM indicator is off (not illuminated) when no alarm
conditions exist.
The indicator lights amber to indicate an OOF alarm. (Other
alarms may also be active.)
The indicator lights red for all other alarm conditions.
POWER
The indicator lights green when power is applied to the unit.
The indicator lights amber in test modes (port looped or BERT
active).
Button Description
RESET
The RESET button provides a hardware reset to the unit.
CONFIG
The CONFIG button sets the unit back to its factory default
configuration for Packet Mode operation; this is the same as a
maintenance reset. To initiate this function, you must press and hold
the
CONFIG button during a power-up sequence.*
Indicator Description
Vista de pagina 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 196 197

Comentarios a estos manuales

Sin comentarios