Verilink T1 Access Router (34-00327) Product Manual Manual de usuario descargar pdf (Pagina 58)

3-30 T1 Access Router

The Endpoint Table and its corresponding DLCIs will be saved in the

configuration database only after at least one endpoint parameter has been

changed and submitted in the Endpoint Details screen (page 3-30).

NOTICE: The Endpoint Table and its corresponding DLCIs will be saved in the

configuration database only after at least one endpoint parameter has

been changed and submitted in the Endpoint Details Screen on

page 3-31. When in IP Gateway, if you decide to use a “discovered”

endpoint, you must rename it. A discovered endpoint cannot be used

elsewhere (i.e., IP Gateway) until it has been renamed. Also, it will not

be saved in the configuration database.

NOTICE: Endpoint names of the form PPP-Sn are reserved by the system. These

system-generated endpoints cannot be modified.

Figure 3.25

Endpoint Table Screen

For most applications, you will not have to modify the Endpoint Table and

DLCI Table. Modification is necessary, however, to configure remote in-band

management. (See In Band Management on page 3-34.)

Endpoint Details Screen

The Endpoint Details screen (Figure 3.26). which you access by clicking on

an Index number on the Endpoint Table, lets you access the configuration

parameters described in the paragraphs below.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 196 197

Sin comentarios

Verilink T1 Access Router (34-00327) Product Manual Manual de usuario Pagina 58