Verilink WANsuite 5230 (34-00304.F) Product Manual Manual de usuario descargar pdf (Pagina 90)

3-60 WANsuite 5260/5230

Static Routes Screen

Under some circumstances, it may not be necessary for a router to learn a

route using ordinary means such as RIP or OSPF. It is possible under these

circumstances for you to add a route to the route table of a router.

The Static Routes menu is always associated with a circuit. Access this menu

by selecting the Static Routes Table from the RIP Parameters Table on the IP

Gateway menu.

Figure 3.47

Static Routes Screen

Endpoint

Endpoint name (or interface) through which to send the IP packet to reach the

Target IP Address.

Target IP Address

Represents the target network that you want this router to reach.

Target IP Mask

Mask of the target network.

Next Hop

IP address of the next device in the route.

Cost

Cost of using that route.

Route Status

Indicates whether a route is enabled or disabled.

The Static Routes Table screen provides the following user-activated buttons:

Route Details Screen

Access this menu by selecting “Route Details” from the Static Route menu.

Button Function

Route Details Displays the static route parameters.

Dynamic Route Table Displays routes learned via RIP or OSPF.

Add New Adds a new static route.

Refresh Refreshes data on the current page.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 232 233

Sin comentarios

Verilink WANsuite 5230 (34-00304.F) Product Manual Manual de usuario Pagina 90