Verilink WANsuite 5230 (34-00304.F) Product Manual Manual de usuario Pagina 212

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 233
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 211
5-16 WANsuite 5260/5230
Figure 5.16
Serial 1 and Serial Interface 2 (5260) or Serial (5230)
Configuration Menu Tree
Type
Selects the type of interface (based on its electrical signal characteristics) used
by the equipment connected to the Serial port.
Values: X.21, V.35, RS-232, EIA-530
Default:V.35
NOTICE: V.35 requires the use of an optional cable. Refer to Optional Equipment
on page A-6 for ordering information.
Mode
By default, the Serial port serves as a DCE port in both Packet and TDM
modes. However, the Serial port can serve as a DTE port when the unit is in
Packet mode.
If the Serial port connects to a DTE device (such as a FRAD or a router), you
must set this Mode parameter to “DCE.” If this port connects to a DCE device
(such as a DSU/CSU), you must set this Mode parameter to “DTE” (valid
only for Packet mode, not TDM).
Values: DCE, DTE
Default:DCE
NOTICE: DTE mode requires the use of an optional DTE cable. Refer to
Appendix A for ordering information.
X.21
V. 3 5
RS-232
EIA-530
Serial 2
Config
Type Mode DSR DCD CTS RTS RTS Dly Tx Clock
DCE
DTE
True
False
Int
True
False
Int
True
False
Int
Normal
True
Normal
Long
Int
Ext
Ch Rate
RateInv Clock Bundling
Start Ch # of Ch
V. 5 4
LL
DTR
Ctrl
Nx64K
Nx56K
Cont
Alt
1–31 1–31 Dis
En
Dis
En
Dis
En
Dis
En
Serial 1
Config
Nx64K
Nx56K
(N = 1–32)
Vista de pagina 211
1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 232 233

Comentarios a estos manuales

Sin comentarios