Verilink WANsuite 5230 (34-00304.F) Product Manual Manual de usuario descargar pdf (Pagina 23)

About the WANsuite 5260/5230 1-9

The user-activated input control buttons used to access and set configuration

and control options from the LCD menus are defined in the table below:

Rear Panel Connections

The rear panel of the WANsuite 5260 has 11 connectors. From left to right

these are as follows:

POWER, SUPERVISORY PORT, 10/100 ETHERNET,

SERIAL 2, SERIAL 1, NET 2 (75 Ω RX), NET 2 (75 Ω TX), NET 1 (75 Ω RX),

NET 1 (75

Ω TX), NET 2 (120 Ω), NET 1 (120 Ω) as shown in Figure 1.2

below.

NET 2 serves as the E1 Equipment Port or DSX Port for the unit.

Figure 1.2

WANsuite 5260 Rear Panel

The rear panel of the WANsuite 5230 has 7 connectors. From left to right,

these are as follows:

POWER, SUPERVISORY PORT, 10/100 ETHERNET,

SERIAL

, and NET (75 Ω Rx), NET (75 Ω Tx), NET (120 Ω) as shown in Figure

1.3 below. The WANsuite 5230 has one E1 port to which you may connect

using either the 75-ohm BNC or the 120-ohm RJ-48C. Refer to, Network 1

Interface (5260) and Network Interface (5230) on the following page for more

information.

Figure 1.3

WANsuite 5230 Rear Panel

Button Description

EXIT

The EXIT button exits a menu option, which then places the unit in the next

higher level of the menu hierarchy. If you are editing an option, pressing

EXIT

exits that screen without saving any changes. If you are in the main menu,

pressing

EXIT logs off the unit.

SCROLL

The SCROLL button lets you review the available options for a given level in

the menu hierarchy or scroll through possible settings for a parameter. You can

also use the

SCROLL button to set alphanumerical values, where applicable, by

scrolling incrementally through digits 0–9 or letters A–Z and a–z.

SELECT

The SELECT button lets you select the currently displayed option or value for a

given field, and enter an “edit” mode for parameters that require user-specified

input. Additionally, you can use the

SELECT button to confirm certain actions

or settings. If this button is held during power-up reset, the configuration is

forced to packet defaults.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 232 233

Comentarios a estos manuales

Sin comentarios

Verilink WANsuite 5230 (34-00304.F) Product Manual Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink WANsuite 5230 (34-00304.F) Product Manual