Verilink Net Engine (3150-30626-001) Product Manual Manual de usuario descargar pdf (Pagina 291)

NetEngine IAD User Guide

Verification 272

Power-up

Test

The NetEngine IAD displays an indication of normal operation when you

first power it up. When you power it up, verify that the POWER indicator on

the front panel lights green.

Operational

Test

Use the following procedure to verify that the IAD is operating properly

after installation. The following procedure assumes that:

You have configured Directory numbers (DNs) in the Class 5 switch for

the associated Voice Ports.

The IAD has been connected to a terminal emulator via the console

port, displays the normal boot sequence and you can log in.

You have configured PVCs at the DSLAM (default data = 0, 38; default

voice is 0, 39) when using ATM.

You have provisioned a data network.

You connected and configured a WAN link at the associated DSLAM

or voice gateway. For more information, see Chapter 6, WAN

Configuration (page 51).

You have a PC with Telnet, and an Ethernet adapter running TCP/IP.

For more information, see Connecting via Telnet on page 16.

For testing, you and a counterpart stationed logged on to the upstream

voice gateway can communicate via telephone or cell phone.

Testing the IAD

1. Verify the WAN link status:

SDSL Interface—the LINK indicator blinks while the IAD synchronizes

with the DSLAM, and lights continuously when the link is established.

T1/E1 Interface—the LINK indicator blinks while the IAD synchronizes

with the voice gateway, and lights continuously when the link is

established.

2. Connect a POTS telephone to a provisioned line port on the IAD.

3. Lift the telephone receiver and check for dial tone

If no dial tone is present, troubleshoot as necessary.

4. Repeat steps 2 and 3 for each provisioned line port.

5. Disconnect the telephone once you are through testing the line ports.

6. Use a crossover cable to connect the PC to the Ethernet LAN port on

the IAD. Determine that the PC is configured with an IP address on the

same subnet as the IAD.

7. Observe that the LINK indicator on the IAD front panel lights to verify

that the IAD is connected to the LAN.

8. Run Ping on the PC to ping a known good address on the IAD and

verify the acknowledgement.

If a timeout occurs, troubleshoot the LAN path to the IAD.

9. Ping a known good address on the network and wait for

acknowledgement.

If a timeout occurs, troubleshoot the LAN path to the IAD.

10. Disconnect the Ethernet cable between the PC and the IAD.

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 322 323

Comentarios a estos manuales

Sin comentarios

Verilink Net Engine (3150-30626-001) Product Manual Manual de usuario Pagina 291

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink Net Engine (3150-30626-001) Product Manual