Verilink Net Engine (3150-30626-001) Product Manual Manual de usuario descargar pdf (Pagina 100)

NetEngine IAD User Guide

WAN Configuration 81

Configuring

ATM PVCs

You may configure up to 8 ATM PVCs on the IAD. To configure create and

manage PVCs, type 3 on the WAN configuration menu. The IAD displays

the ATM PVC Configuration menu:

Figure 4–36. ATM PVC Configuration Menu

Type the option to perform a task. Proceed to the corresponding section.

Adding a New PVC (page 81)

Modifying an Existing PVC (page 83)

Deleting an existing PVC (page 89)

Displaying the Current PVCs (page 89)

Adding a PVC

To add a PVC, follow these steps:

1. On the ATM PVC Configuration menu, type 1 to select Add New PVC.

2. The IAD displays a prompt for the VPI:

Enter Virtual Port Identifier (VPI):

Type a VPI value between 0 and 255 (default 0) and press Enter.

3. The IAD displays a prompt for the VCI:

Enter Virtual Circuit Identifier (VPI):

Type a VCI value between 32 and 65535 (default is 38 for data, 39 for

voice) and press Enter.

*****************************************

ATM PVC Config Menu

*****************************************

1. Add New PVC

2. Modify Existing PVC

3. Delete PVC

4. Show Current PVCs

NOTE

Before you configure PVCs, you must first set the datalink

protocol to ATM. If option 3 on the WAN Configuration menu

displays Configure DLCIs instead of Configure PVCs, it is

because your datalink protocol is set to Frame Relay instead

of ATM.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 322 323

Sin comentarios

Verilink Net Engine (3150-30626-001) Product Manual Manual de usuario Pagina 100