Verilink WANsuite 6450 (34-00326) Product Manual Manual de usuario Pagina 171

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 205
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 170
VT100 Interface 4-63
TCP Connection Timer
The maximum time (in seconds) NAT will use resources when attempting to
establish a TCP connection.
Values: 065535
Default: 300
TCP Closing Timer
The maximum time (in seconds) NAT will use resources when attempting to
close a TCP connection.
Values: 065535
Default: 0
TCP Disconnected
Timer
The maximum time (in seconds) NAT will use resources when attempting to
disconnect from TCP.
Values: 065535
Default: 120
TCP Sequence Delta
Timer
The maximum time (in seconds) NAT will use resources when managing TCP
Packet Sequencing.
Values: 065535
Default: 180
UDP Timer
The maximum time (in seconds) NAT will use resources for a UDP port in
use.
Values: 065535
Default: 120
ICMP Timer
The maximum time (in seconds) NAT will use resources for any ICMP
request.
Values: 065535
Default: 120
The NAT Details screen provides the following user-activated prompts:
Static TCP Trans Table Screen
The Static TCP Trans Table screen (Figure 4.55) allows static mapping of
global TCP Server ports to a local host IP Address/port combination. The
parameters described below enable access to TCP servers on the private/
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Prompt Function
Static TCP Translation Table Allows static mapping of global TCP Server ports to
a local host IP Address/port combination.
NAT Ports Defines NAT global/Internet and local/corporate
ports.
Static UDP Translation Table Allows static mapping of global UDP Server ports to
a local host IP Address/port combination.
Vista de pagina 170
1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 204 205

Comentarios a estos manuales

Sin comentarios