Verilink WANsuite 5650 (34-00314.E) Product Manual Manual de usuario descargar pdf (Pagina 16)

1-4 WANsuite 5650

initiate/terminate tests and the corresponding LEDs indicate the status of tests

on this port only.

When on the G.703 port selection, the

G.703

port LED flashes as an

indication. If there is only a single service on the G.703 port then the

LOCAL

LOOP/ERR INJ

and

REMOTE LOOP

buttons initiate/terminate tests and the

corresponding LEDs indicate the status of tests on this port only.

When on the SHDSL port selection, the

SHDSL

port LED flashes as an

indication. The

LOCAL LOOP/ERR INJ

and

REMOTE LOOP

buttons initiate/

terminate tests and the corresponding LEDs indicate the status of tests on this

port only. These tests are on the aggregate SHDSL payload.

The

REMOTE LOOP

button will invoke a G.SHDSL Network Side Transparent

Loop (see figure A.1).

Either the G.703 port or the Serial interface Nx64 will have transparent loop

with the

LOCAL LOOP

button (see figure A.2 or figure A.3).

NOTICE:

PORT SELECT will not operate if any locally initiated tests are in

progress.

Local Loop/Error Inject Button

Default: Enabled.

Remote Loop Button

Default: Enabled.

BERT Button

Default: Enabled.

LED Indicators

The table below describes the WANsuite 5650’s front panel LED indicators.

NOTICE:

The

SHDSL

G.703

, and

Nx64

port LEDs will flash when selected by the

port select button

NOTICE:

When no port is selected (indicated by none of the port LEDs flashing),

only the PORT SELECT button is enabled.

NOTICE:

When no port is selected, the

and

LEDs display a summation of

the test states of the

Nx64

(serial interface),

G.703

, and

SHDSL

ports.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comentarios a estos manuales

Sin comentarios

Verilink WANsuite 5650 (34-00314.E) Product Manual Manual de usuario Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink WANsuite 5650 (34-00314.E) Product Manual