Verilink WANsuite 5165 (34-00301.H) Product Manual Manual de usuario Pagina 175

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 235
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 174
VT100 Interface 4-51
Enter IP Port or Select
From List
Establishes the IP port by which the rule will filter IP traffic (if enabled).
Filter By IP Port
Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.
Tx Alarm Threshold
Specifies the threshold in bits per second for the Transmit Alarm on this rule.
Tx Alarm
Shows the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen, which can be accessed from the bottom of
the Rule Config screen, displays the number of frames and octets sent over a
DLCI that have been counted in accordance with the Service Aware “rule”
that has been established for a Service. As such, it is frame relay specific (i.e.,
DLCIs only occur in frame relay links). In addition, this screen provides data
rate performance information for the period of time you have specified in the
Period Index field (see below).
Figure 4.43
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen reports on the following parameters:
Tx Frames
Tx Octets
Rx Frames
Rx Octets
Rate Peak – the peak data rate for the viewed period (see below)
Rate Average – the average data rate for the viewed period (see below)
The <Period> indicates the period of time for which the Traffic Meter
statistics are reported as listed below.
Vista de pagina 174
1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 234 235

Comentarios a estos manuales

Sin comentarios