Verilink PRISM 3060-10 (34-00252.4) Product Manual Manual de usuario descargar pdf (Pagina 21)

Power Connection 13

The physical connection is a 6-pin modular jack with the following pinout

assignments. The port is a serial RS232-level port configured for 8 bits, no parity,

and 1 stop bit.

Power

Connection

The unit is factory equipped with a standard three-prong AC cord and is fused at

1.0 ampere.

Remove power before checking fuses.

On power up, the board initialization sequence causes a delay. During this period, the

message on the front panel shows Calculating Checksum.

Connect the AC power cord to an appropriate AC power receptacle.

Set the rear panel power ON/OFF switch to the ON position (labeled l). The green

power LED on the front panel should light after the LED initialization sequence

ends. If the indicators do not light, recheck the power connections and the primary

AC circuit breaker. Make sure the ON/OFF switch is in the ON position.

Table 2-6 SUPV Port Pinout

Pin SUPV Port Interface

1Control Out

2, 5 Signal Ground

3Data Out

4Data In

6Control In

✍

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 75 76

Sin comentarios

Verilink PRISM 3060-10 (34-00252.4) Product Manual Manual de usuario Pagina 21