Verilink PRISM 3060-10 (34-00252.4) Product Manual Manual de usuario descargar pdf (Pagina 15)

Unit Configuration 7

Unit

Configuration

Configuration is performed using one of the following methods:

✦ The front panel LCD interface (see Chapter 3 of this manual).

✦ A terminal connected to the SUPV or the NMS port (see Chapter 4 of this

manual).

The 3060-10 provides non-volatile memory retention of unit configuration in the

event of power failure. This feature allows the unit to automatically restore normal

service following a power loss. Note, however, that when the unit is stored without

power for an extended period, the battery may drain and some parameters may

become corrupted.

Therefore, when the unit is first received for installation or if power has not been

applied for an extended period of time, a factory-default maintenance reset

operation should be performed on the unit. Refer to the procedures detailed in

Maintenance Reset on page 16.

FCC rules require that interconnecting cables carrying high-speed data be shielded

appropriately to minimize radio frequency interference.

DSU MP Port

Connections

The DSU MP physical interface is two standard D-subminiature, 120-pin female

connectors (Figure 2-2) that break out with two of the cable assemblies

(Figure 2-3). The pinout assignments are shown in Table 2-1.

1-3

4-6

Figure 2-2 DSU MP Rear Panel with Two Female D-subminiature 120-pin Connectors

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 75 76

Sin comentarios

Verilink PRISM 3060-10 (34-00252.4) Product Manual Manual de usuario Pagina 15