Verilink DPRI 2922 (880-503142-001) Product Manual Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
DPRI 2922 Dual-Port ISDN Primary Rate Interface
BACK HOME GLOSSARY INDEX
1-4 Verilink DPRI 2922
Two for data port status
Chapter 4 of this manual defines the LEDs and alarms.
Management Ports
Three NCM front panel management ports support management of
the local node and allow remote node management.
Local—RJ-11 direct connection to the Craft interface via:
•An ASCII terminal
A PC running a terminal emulator
Node Manager ASCII Port Access window
The DPRI 2922 also supports access to the ASCII interface over NCM
Telnet sessions via modem dial-up SLIP connections.
PRI—Primary Management. Node Manager interface connection
to the PC COM port.
Type Serial port used for Node Manager access or
ACP bus extension
Connector RJ-45 (8-pin), RS-232-compliant
EXT— Multishelf Management. Extension port for daisy-
chaining multiple AS2000 shelves (ACP-bus modules only).
Type ACP management
ext
ension port
Connector RJ-45 (8-pin), RS-232-compliant
The PRI and EXT ports can be used interchangeably.
Connector
Interface
Modules
The DS-1 CIM 29010 and the DS-1 CIM 29011, shown in Figure 1-3,
support dual RJ-45 network port connectors and either dual V.35 or
dual EIA530/RS449 data port connections. They also provide the
following interfaces:
Alarm relay
Loss of carrier conditions activate the relay contacts. These
contacts can be wired to external alarm equipment. The
connector pins provide output as a normally open (NO)
contact, a normally closed (NC) contact, and a common (COM)
lead contact.
External timing source input
The 8-pin mini-DIN connector receives a clock signal from an
external timing device.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 90 91

Comentarios a estos manuales

Sin comentarios