Verilink Craft Interface (No Part Number) Product Manual Manual de usuario descargar pdf (Pagina 5)

Using the Craft Interface

Verilink Craft Interface Craft-5

Command Line

Prompt

The initial prompt defaults to the module directly connected to the

Craft interface cable. The command line prompt is defined below:

[0.0.0.1] [0,11] NCM 2000 >

Where:

[0.0.0.1] is the node address of the node to which you are

connected. This number is used by modules and the Verilink

Node Manager application to identify a node. Each AS2000

node has a unique address. This value is completely unrelated

to an Ethernet IP address.

NOTE: The first three digits of the node address must NOT be greater than

127.

[0,11] is the shelf number and slot number of the currently

selected module. NCM 2000 is a sample of the command line

prompt, showing the model name of the currently selected

module.

This field reads UNKNOWN > when the shelf/slot location is

empty, the element has been removed, or if the module is not

recognized by a controller module.

Entering

Commands

Commands can be entered in upper or lower case.

To clear a command entry mistake, exit from the command before

entering a complete parameter value by pressing E

NTER

To clear typed entries and start again, press C

ONTROL

-U. The

backspace key can also be used to make corrections.

If you enter an invalid value, you will be prompted with a message

that the value is invalid and be returned to the current menu.

Conventions Used

The Craft interface uses the following conventions:

•

In application modules with multiple network or data ports, an

is used to represent the port number. For example, to put

Port 2 in service, type “I2” instead of “In”. In some older

modules “p” represents the port number.

•

Ranges of permitted values are depicted with ellipses. For

example, you can choose any number in the range 1 to 127

seconds to indicate the Alarm Declare Time. This is shown as

1..127. However, when you provide input indicating ranges,

do so with a dash: 1-24. This example indicates all numbers

between 1 and 24, including the numbers 1 and 24. You can

also intermix single numbers with range definitions if they are

separated by commas, such as: 24, 38-45, 60.

•

Fields

without

a closed parenthesis, ), are status/informational

fields.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Verilink Craft Interface (No Part Number) Product Manual Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink Craft Interface (No Part Number) Product Manual