Verilink AS4000 (34-00244) Product Manual Manual de usuario descargar pdf (Pagina 41)

Hardware Installation

Verilink AS4000 User Manual 3-5

1. Slide the rear connector module into the back of the assigned

shelf slot, ensuring both connectors mate with the

corresponding shelf connectors.

2. Verify the top and bottom of the interface card is flush with

the shelf.

3. Secure the rear interface card by tightening the two thumb

screws finger-tight on the ends of the panel.

4. Repeat the above procedure for each remaining rear interface

card.

Installing the

Application Card

To install the application card, do the following:

Figure 3-3 Application Module Installation into a Multi-line Shelf

1. Slide each application card into its assigned slot until it seats

in the midplane (Figure 3-3).

2. Position the ejector handles flush with the faceplate, locking

the application module into the shelf.

3. Secure the front application card by tightening the two thumb

screws finger tight on the ends of the panel.

CAUTION

All shelf slots must be filled with an application module or a face plate.

Failure to fill all shelf slots can result in Radio Frequency Interference

(RFI). See the FCC Statement advisory in the front matter of this manual.

Midplane

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 209 210

Sin comentarios

Verilink AS4000 (34-00244) Product Manual Manual de usuario Pagina 41