Verilink WANsuite 5370 (34-00310.D) Product Manual Manual de usuario Pagina 209

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 235
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 208
Front Panel LCD Interface 5-11
Gateway Address
This option lets you define the IP address of the default gateway (router) on
the LAN side of the unit. To establish the Gateway Address, press the
SELECT button to activate a blinking cursor over the first digit’s location (an
“x”) in the address, indicating the value is selected for change. Press the
SCROLL button to incrementally change the selected digit’s value (0-9). When
the desired value for a selected portion of the address is displayed, press the
SELECT button to set that value and to move to the next value in the address.
Pressing the
SELECT button while the blinking cursor is on the last digit
enters the value and returns you to the previous screen. Pressing the
EXIT
button at any time while entering a Gateway address aborts the edit.
DHCP Client
If DHCP Client is enabled at power-up, the unit will request its IP, Mask, and
Gateway addresses from a DHCP server located on the LAN side of the unit,
and the unit will use these addresses. If the DHCP request is unsuccessful, the
unit will use the configured addresses shown on this screen.
NOTICE: Always verify that a DHCP server is available on the network before
enabling DHCP Client. If, on power-up, a DHCP server is not found, a
60-second timeout will occur.
Ethernet
Enables or disables a remote unit’s Ethernet port.
Network Configuration Menu
Use the NET CONFIG menu to set up parameter values for the DDS port
labeled as
NET on the WANsuite 5370 (Figure 5.11).
Figure 5.11
Network Configuration Menu Tree
The Network interface can have independently selected values for the
following parameters:
Mode
Selects the network service type.
Values DDS II - 64k, DDS I - 56k
Default: DDS II - 64k
Timing
Sets the timing source to synchronize the unit’s internal timing generators.
Choices are as follows:
Network Timing is derived from the network recovered clock. (Most
applications use this selection.)
Net
Config
Mode
DDS II - 64k
DDS I - 56k
Timing
Net
Internal
Vista de pagina 208
1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 234 235

Comentarios a estos manuales

Sin comentarios