Verilink WANsuite 5330 (34-00302.F) Product Manual Manual de usuario descargar pdf (Pagina 32)

3-4 WANsuite 5330

The Unit screen provides the following user-activated buttons:

Maintenance Reset

Use this button to access a screen where you can perform a Maintenance

Reset (Figure 3.2). When you click on the arrow in the pull-down menu box

on the screen, you will have the option to perform a TDM, Packet, or Packet

4 reset. When you select one of these options, all previous configurations will

be lost and the unit will be set back to the specified factory default.

Figure 3.2

Maintenance Reset Screen

NOTICE: Performing a “Maintenance Reset” or a “Save and Restart” will

terminate communications with the unit. A “Refresh” should be

performed after approximately 10 seconds to restore communications.

Save and Restart

Use this button to save the current configuration settings and then restart the

unit. Clicking the “Save and Restart” button on the Unit screen will display a

confirmation screen as shown in Figure 3.3 below. Click the “Save and

Restart” button on the confirmation screen to confirm the action.

Button Function

Submit Sets any values that have been changed. The top “Submit”

button sets any unit parameters changed in the upper section of

the screen, and the lower “Submit” button sets the real-time

clock.

Maintenance Reset Resets unit to its default TDM or Packet configuration.

Save and Restart Saves the current configuration and restarts the unit.

Refresh Refreshes data on the current page.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 134 135

Sin comentarios

Verilink WANsuite 5330 (34-00302.F) Product Manual Manual de usuario Pagina 32