Verilink SCM (880-503300-001) Product Manual Manual de usuario descargar pdf (Pagina 41)

Administration Menu

Verilink SCM 4-3

Table 4-1 Administration Menu Commands

Menu Option Description Instructions

H) set shelf type Define or change shelf types of each

shelf in local node.

See the subsection:

“Set Shelf Type”

T) set time Sets time for all modules in the node. Use format hh:mm:ss to set time. Set

the time zone, then date, and then

time. This order is important.

B) download firmware Firmware download to selected

modules (other than the SCM itself).

See Chapter 6,

“Downloading and

Broadcasting Firmware”

W) write file to flash Stores previously downloaded firmware

in flashbank on this SCM card.

See Chapter 6,

“Downloading and

Broadcasting Firmware”

C) set front/rear access Set management port access. Front

back, not both at same time.

The default is front access.

A) set node address Changes local node address. This is not

the Ethernet IP address. This is the

prompt line address [0.0.0.1]. The

value for each SCM

must

be unique.

Never

set first octet greater than 127.

Will cause momentary reset of SCM as it

updates database records. Used by

Verilink Node Manager application.

I) change site name Changes local node site name as it

appears on second line of Main Menu.

Enter up to 19 alpha-numeric

characters.

N) TCP/IP parameters Ethernet/SLIP, SNMP, Trap Host, and

TCP/IP addresses and options.

See the section:

“TheTCP/IP

Configuration Menu”

M) modem parameters SCM SLIP modem interface menu. See the section:

“Configuring Modem

Parameters”

K) show shelf_master Displays which module is driving the

backplane sync clock.

Reference information for Technical

Support. See

AS3000: the Basics

Chapter 2, “System Information”, for

further details.

X) exit this screen Exits to SCM Main Menu.

Z) set time zone Set time zone for all modules in node. Select time zone from list presented, or

use custom for GMT offset in hours +/-.

Enable/Disable Daylight Savings option.

Set the time zone, then date, and then

time. This order is important.

D) set date Set date for all modules in node. Use the format: mm/dd/yy for month,

day, and year. Set the time zone, then

date, and then time. This order is

important.

Y) switch over once Executes selected firmware image

ONCE. The switchover is not

permanent. Use to test firmware

upgrades.

See Chapter 6,

“Downloading and

Broadcasting Firmware”

O) switch over

permanent

Sets which flash bank to boot from at

power up (setting saved on reset).

See Chapter 6,

“Downloading and

Broadcasting Firmware”

Q) query firmware Displays status of firmware revisions in

partition banks of selected module.

Results displayed after about 60

seconds.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 82 83

Comentarios a estos manuales

Sin comentarios

Verilink SCM (880-503300-001) Product Manual Manual de usuario Pagina 41

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink SCM (880-503300-001) Product Manual