Verilink Red Zone Encryption (REMS) (880-502423-001) Produc Manual de usuario descargar pdf (Pagina 65)

Configuring REMS using the thumbwheel switch

Red Zone Encryption Management System (REMS) User Manual

6-5

FBR Thumbwheel Configuration Commands

40 Canned FBR Option 1 (Remote REMS is the

default.)

64 FBR is Master

65 FBR is Remote

68 Disable Re-sync (Default)

69 Re-sync= 2 seconds

70 Re-sync= 4 seconds

71 Re-sync= 6 seconds

72 Re-sync= 8 seconds

73 Re-sync= 10 seconds

80 D4

81 ESF

82 AMI

83 B8ZS

Procedure for

configuring the

BRC

Using the BRC thumbwheels (located on the front panel of the BRC NCC

2020), select the BRC timing mode for each BRC in the circuit. Refer to

the subsection, BRC Timing Options, below.

1. Access the BRC by entering its location address into its the

thumbwheel switches (located on the front panel of the BRC NCC

2020).

The STATUS light on the front panel of the NCC begins flashing

Green. (You have 60 seconds to perform the next step.)

2. Using the FBR thumbwheels (located on the front panel of the FBR

NCC 2020), set the FBR to 40. This is the “canned” (preconfigured)

FBR option.

The NCC STATUS light stops flashing.

3. Select the BRC timing mode for each BRC in the circuit. Refer to the

subsection, BRC Timing Options, below.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 96 97

Sin comentarios

Verilink Red Zone Encryption (REMS) (880-502423-001) Produc Manual de usuario Pagina 65