Verilink NCM 2000 (880-502623-001) Product Manual Manual de usuario descargar pdf (Pagina 32)

Craft Interface

-8 Verilink NCM 2000

Command

Examples

Some commands are shown with a lowercase character. The

character, usually n or p, represents a variable. Enter a number in

place of this lowercase placeholder. For example:

Dn) delete node

Where n is the number of the local or remote node.

Type:

"d1"

If you type "Dn", you will get an error message.

Command Line

Prompt

The initial prompt defaults to the Node address of the local NCM.

The command line prompt is interpreted as follows:

[0.0.0.1] [0,11] NCM 2000 >

Where:

[0.0.0.1]

is the node address of the local node to which

you are connected. This number is used by

NCM modules and the Verilink Node Manager

application to identify each NCM (and node).

This value is completely unrelated to the

Ethernet IP address of the NCM.

NOTE:

The first three digits of the node address must NOT be greater than

127. For example a node address of 128.7.5.251 will render certain

critical NCM functions inoperative

NOTE:

The node address 127.255.255.255 should not be assigned to any

node. It is used internally by the system to broadcast to all nodes.

NOTE:

In a network with multiple NCM sites, each NCM must have a unique

address as shown in the command line prompt.

U=DCSU Dual CSU

DCSU 2911

•

Four port T1 or E1 CSU in

one card.

V=VCU Voice Channel

Unit

Not available

W=DHDM_

POET

Dual Port DS3 HDM 2182

•

Two T3 ports No

X=QPRI Quad Primary

Rate Interface

QPRI 2921

•

Four port ISDN aggregate;

use with IMUX module

Yes, for

ISDN

Key Symbol

and Name Generic Name Model Number

Bus

ACP TABS Comment

NCM

Required

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 90 91

Comentarios a estos manuales

Sin comentarios

Verilink NCM 2000 (880-502623-001) Product Manual Manual de usuario Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink NCM 2000 (880-502623-001) Product Manual