
Verilink NCC 2130 User Manual
2
-1
Chapter
2
Quick Set-Up
This section details a quick, step-by-step procedure for configuring
the NCC 2130. For this quick configuration guide, the following
assumptions are made:
• That you are using the NCC 2130 with a fractional ESF/B8ZS T1
circuit.
•
That timeslots one through twelve are to be used for the one
available data port on the NCC 2130.
•
That you are using a Cisco™ router for a connection to the
Internet.
Figure 2-1 Example Configuration
It is most likely that this procedure will not match your
configuration exactly. Use this chapter as a guide to the process of
installing your equipment. Chapter 3 provides complete details on
configuration covering all selectable options.
Connect to Craft
Port
Using the Craft cable supplied with the NCC 2130, connect the
modular (RJ-11) end to the port labeled
C
RAFT
on the front panel of
the NCC 2130. Connect the other end of the Craft cable to your PC
or terminal. If your PC has a DB-9 COM port connector, use a
standard PC-AT serial cable to complete the connection.
Set your terminal, or terminal program, to 19.2 kbit/s, 8 data bits,
no parity, one stop bit, and
no flow control.
Login
•
Press
E
NTER
.
•
The prompt, YOUR PASSWORD?
YOUR PASSWORD? YOUR PASSWORD?
YOUR PASSWORD? is displayed.
•
Initially there is no password, press
E
NTER
.
•
The NCC 2130
Main Menu
is displayed:
NOTE:
The prompt line and menu names refer to the NCC 2130 as
an IDCSU 2130. This is because an NCC 2130 is a TAC 2130
Integrated DSU/CSU to which the Craft interface and node
controller functions have been added.
N
C
C
2130
NET
STAT
EQPT
CR
AFT
F
U
N
C
T
I
O
N
EQ
PT
5
7
EXE
IN
O
U
T
IN
O
U
T
N
E
T
E
Q
PT
N
ET
M
O
N
Router
NCC 2130
Internet
Comentarios a estos manuales