Verilink PRISM 4001 (34-00244) Product Manual Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 34
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
Installation 2-3PRISM 4001
If in Standard mode, set the DTE Rate as shown in Table 2-F.
Configuration Switch S2
Switch S2 (Figure 2-3) is used to set the configuration
parameters listed in the following paragraphs.
DTE M
ODE
Position S2-1 sets the unit to one of two general modes:
Sync or Async (Async is allowed only in the TxPORT-pro-
prietary mode) as shown in Table 2-G.
D
ATA
M
ODE
Position S2-2 sets the communication link to proprietary
mode (TxPORT equipment must be located on both ends) or
to industry-standard mode (it interoperates with standard
equipment from another vendor) as shown in Table 2-H.
RTS C
ONTROL
Position S2-3 sets the behavior of the RTS and CTS as
shown in Table 2-I.
RTS-
TO
-CTS D
ELAY
Position S2-4 sets the delay on an RTS-to-CTS transition as
shown in Table 2-J.
L
OOP
M
ODE
Position S2-5 selects the loopback method as shown in
Table 2 -K.
D
OWNLOAD
ON
R
ESET
Position S2-6 is used in conjunction with the front panel
FAR/LOC switch to force the 4001 into a software down-
load mode as shown in as shown in Table 2-L. The FAR/
LOC switch controls the download baud rate as shown in
Table 2-M. If S2-6 is in the Up position at power up, the
4001 enters download mode at the rates specified by the
FAR/LOC switch.
Table 2-F DTE Rate in Standard Mode
DTE Rate S1-6 S1-7 S1-8
56 kbps
Down Down Down
64 kbps Down Down Up
2.4 kbps Down Up Down
4.8 kbps Down Up Up
9.6 kbps Up Down Down
19.2 kbps Up Down Up
38.4 kbps Up Up Down
Table 2-G DTE Mode
DTE Mode S2-1
Sync
Down
Async Up
Table 2-H Data Mode
Data Mode S2-2
Standard
Down
TxPORT Up
7654321
Down Up
8
DTE
Data
RTS
Boot
Boot
Mode
Mode
Mode
Mode
Down-
load
Control
RTS/CTS
Delay
Switch
S2
Loop
Mode
Figure 2-3 Switch S2
Table 2-I RTS Control
RTS Control S2-3
Normal
Down
Forced On Up
Table 2-J RTS-to-CTS Delay
RTS-to-CTS Delay S2-4
Normal
Down
Long Up
Table 2-K Loop Mode
Loop Mode S2-5
Bidirectional
Down
Unidirectional Up
Table 2-L Download Mode
Download on Reset S2-6
Run EEPROM
Down
Do Download Up
Table 2-M Download Baud Rate
Baud Rate FAR/LOC Position
57.6 kbps FAR
38.4 kbps Center
19.2 kbps LOC
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Comentarios a estos manuales

Sin comentarios