Verilink SCC 2130 (880-503282-001) Product Manual Manual de usuario descargar pdf (Pagina 29)

Configuration

Verilink SCC 2130 User Manual

-9

Node Administration

In addition to the T1 CSU/DSU functions, the SCC 2130 is also an

SNMP node controller. The

Node Administration Menu

, and

submenus beneath it, are used to configure site, Ethernet and SLIP

address and information.

Some functions on the

Node Administration Menu

support

firmware upgrade procedures.

Node

Administration

The

Node Administration Menu

is accessed by selecting O on the

SCC 2130

Main Menu

. Figure 3-3 shows the options presented.

Most of the commands on the

Node Administration Menu

are

documented in Table 3-5 below.

Some of the menu options on the

Node Administration Menu

will

produce submenus with detailed selections, the

Modem

Configuration Menu

is detailed in Table 3-6.

G) Alarm Determines whether

or not alarm

messages are

presented.

0(Disable) — Alarm reporting is turned off.

1(Enable) — Alarm reporting is enabled, messages will

appear on the Craft terminal as alarms occur and clear.

V) Data Invert Sends ones as zeroes

and zeroes as ones.

If used at one end of

a T1, must be used at

both ends of the T1.

Data inversion is sometimes used to manipulate ones

density. If it is known that the data from a particular DTE

will always have more zeroes than ones, data inversion will

make it have more ones than zeroes. Use of this option to

attempt 64K per DS0 bandwidth over an AMI facility is not

recommended.

X) exit menu Exit this menu. Returns to the SCC 2130

Main Menu

Menu Option Description Instructions

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 72 73

Comentarios a estos manuales

Sin comentarios

Verilink SCC 2130 (880-503282-001) Product Manual Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink SCC 2130 (880-503282-001) Product Manual