Verilink PRISM 4151 (34-00258) Product Manual Manual de usuario descargar pdf (Pagina 14)

3-2 Configuration

PRISM 4151

CTS Delay:

Switch S2-5 allows you to determine the CTS

delay as being either Short (Dn) or Long (Up).

RTS, CTS, DCD Handshake:

Switch S2-6 determines the

handshake process as either Force True (Dn) or Normal

(Up).

Remote/Local Loop:

Switch S2-7 disables (Dn) or enables

(Up) remote and local loop activation by the RL and LL pins

on the DTE interface.

DTE Alarm:

Switch S2-8 disables (Dn) or enables (Up) the

DTE alarm. The DTE alarm is generated when DTR from

the DTE device is false.

Software Configuration

The terminal interface is a firmware application program

embedded inside the PRISM 4151. You can access this

information through the LAN port (page 2-2), SUPV port

(page 2-3), or SLIP port (page 2-3) using a TELNET ses-

sion.

Interface Start-up

Once a compatible terminal is properly connected to the

unit, you can start a terminal interface session by sending a

BREAK command to the unit (or by pressing <return> four

times). If a password has been previously establish, you

must enter the correct password to continue the session.

The

password is case-sensitive.

If you have forgotten your pass-

word, note the date and time shown on your screen and con-

tact TxPORT Technical Support. You can establish a

password through the Utilities screen on page 3-10.

Once a valid password has been entered, the Main Menu

screen is displayed. If you are unfamiliar with the PRISM

4151 interface, commands, and menu structure, refer to

Appendix A,

Terminal Interface

, for specific information

concerning the menu structure and operator commands.

If you do not enter a keystroke for

10 minutes, the terminal interface

automatically logs off.

Configuration Screen

The Configuration screens allow you to view and set config-

uration parameters for the network elements.

To send a new configuration to the unit, you must

press <return> on one of the fields or exit the

screen. The underlined values are the factory

default parameters.

Table 3-H Timing Source

S2-3 S2-4 Timing Source

Dn Dn Network

Dn Up Internal

Up Dn DTE

Up Up Not Used

Alarm

Configuration

page 3-5

DTE Port

Parameters

page 3-4

SNMP

Configuration

page 3-7

Configuration Menu

Summary

page 3-9

TCP/IP

Configuration

page 3-6

Management

Ports

page 3-8

Figure 3-9 Configuration Menu

DDS Network

Parameters

page 3-3

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comentarios a estos manuales

Sin comentarios

Verilink PRISM 4151 (34-00258) Product Manual Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Verilink PRISM 4151 (34-00258) Product Manual